Chapter 3
Programming Advanced Modes: LOG 2 and LOG 3
Use LOG 2 or LOG 3 modes for unattended recording and setting user
protocols. With LOG 2 and LOG 3 modes you can set the start date, start
time, test length, logging interval, number of tests and the time delay
between tests. All or selected parameters can be set.
To program a protocol for LOG 2 or LOG 3 mode:
1. Make sure the D
USTTRAK monitor is connected to the computer and
turned on.
2. Select Logging Setup from the Instrument Setup menu. The T
RAKPRO
software retrieves the current settings for LOG 2 and LOG 3 modes
from the D
USTTRAK monitor and displays them in the following dialog:
05/09/2006
05/10/2006
To Next Page
Loading...
