Setting-Up
Figure B–12: Tighten Velcro Around Battery.
• Connect the external battery pack to the D
USTTRAK monitor by
inserting the power plug protruding from the battery to the power
jack in the top of the D
USTTRAK monitor.
Mounting to a Surveyor Tripod
Enclosure may be
mounted to a standard
surveyor tripod equipped
with a
5
⁄8”-11 threaded
stud. Mounting the
Enclosure on a tripod is
useful when doing
outdoor site monitoring.
Figure B-13 shows the
Environmental Enclosure
mounted on a surveyor
tripod.
Figure B–13: Enclosure
Mounted on a Tripod.
Caution
Do not place the Environmental Enclosure in direct contact
with the ground. The bottom of the Environmental Enclosure
contains an exhaust port that may allow water to enter the
enclosure, resulting in damage to the D
USTTRAK monitor.
To Next Page
Loading...
