EasyManua.ls Logo

TSI Instruments DustTrak 8520 - Specifications: Environmental Enclosure

TSI Instruments DustTrak 8520
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
73
Specifications: Environmental Enclosure
Specifications are subject to change without notice.
Sampling Conditions:
Operating Temperature: . 0 °C to 50 °C (32 °F to 120 °F)
Wind Speed: .................... 0 m/s to 10 m/s (0 mph to 22.5 mph)
Aerosol Concentration
Range: ............................. 0.001100 mg/m
3
(calibrated to respirable
fraction of standard ISO 12103-1, A1 test
dust)
Storage Temperature: ...... -20 °C to 60 °C (-4 °F to 140
Zero stability: .................... ±0.001 mg/m
3
over 24 hours using
10-second time-constant
Particle size range: .......... 0.1approximate 10 µm (Upper limit is
dependent on flow rate)
Flow rate: ........................ 1.7 L/min.
Temperature coefficient: .. +0.001 mg/m
3
per °C (for variations from
temperature at which D
USTTRAK monitor
was zeroed)
Physical:
External dimensions: ........ 406 mm x 330 mm x 191 mm
(16 in. x 13 in. x 7.5 in.)
Weight (with battery and
D
USTTRAK monitor): ......... 7.2 kg (15.8 lb.)
USER MAINTENANCE:
Maintenance Check/
Data Collection: ................ Daily
Clean inlet: ....................... Weekly or daily if concentrations of over
30 mg/cm
3
are measured.
Re-grease O-rings: .......... As needed
Power Requirements:
External Battery Pack: ..... 6 VDC, 10 Ah
Battery run-time: .............. 2460 hours (typical)

Table of Contents

Related product manuals