Setting-Up
Transporting the Environmental Enclosure
When transporting the Environmental Enclosure it is important to store its
components correctly. The following steps should be taken to ensure that no
damage is done to the enclosure or its components during transportation:
Attention
The Environmental Enclosure is designed to protect equipment
during stationary sampling only.
Do not transport or ship equipment inside the Environmental
Enclosure.
• Unscrew the aerosol inlet from the top of the case, and install it into the
inlet-mounting bracket inside the lid of the enclosure.
• Insert the Inlet Transport Plug into the opening in the inlet ring in the
top of the box.
• Empty any water from the water trap.
• Remove D
USTTRAK monitor and battery pack.
• If mounted on a tripod, take the enclosure off the tripod and screw in the
tripod mount plug.
Wiring the Analog/Alarm Cable in the Enclosure
You may desire to install the Analog/Alarm cable to the D
USTTRAK monitor,
when operated inside the Environmental Enclosure. The serial connector,
installed in the side of the enclosure, may be used for this purpose.
Note: If additional penetrations are made into the wall of the enclosure,
you should take precautions to install a sealing (water-tight)
connector around the cable.
To Next Page
Loading...
