21
INFO MODE
Load Menu from USB or Smart Card
NOTE: To update a menu, you may need to verify
that access to the Load Menu screen is turned on.
See page 15 for details.
USB setup: When loading from USB, the menu can
be in XTM (ChefComm) or BIN (binary) format.
The files must be loaded on the root of the USB.
The oven will also detect menus if they are stored in
a folder named TC_Menus.
To load a menu to the oven,
1. When the oven is off or cooling down, insert
the USB or smart card (see below). The oven
will automatically detect the device. Touch
“OK” to proceed.
2. Load the menu:
a. Touch “Load Menu to Oven.”
b. Touch “OK” to confirm the selection and
begin the installation.
NOTE: When loading a menu from a USB,
a copy of the current oven menu will be saved
to the USB.
C. Touch the menu to be loaded.
NOTE: If multiple menus are on the USB,
the oven will display the menu names. Otherwise
this step will be bypassed.
3. Once installation is complete, the oven
will display “Installation Complete.”
Save Menu to USB or Smart Card
NOTE: To save a copy of the oven menu, you may
need to verify that access to the Load Menu screen
is turned on. See page 15 for details.
1. When the oven is off or cooling down, insert
the USB or smart card (see Figure 24, adjacent).
The oven will automatically detect the device.
Touch “OK” to proceed.
2. Save the menu:
a. For USB, touch “Save to USB.”
b. For smart card, touch “Save to Card.”
Continued on next page...
NOTE: Gold chip must
face away from you.
Figure 24: Inserting Smart Card/USB Device
To Next Page
Loading...
Need help?
General