22
INFO MODE
...continued from previous page.
3. Touch “OK” to begin saving the menu to the USB
or smart card. Touch “CANCEL” to go back to the
previous screen.
4. Once installation is complete, the oven will display
“Save Complete.”
NOTE: If saving the menu to USB, the menu file will
be saved in a folder named: TC_Menus. If this folder
does not exist on the USB drive, the oven will create it.
Firmware Update
TurboChef may at some point recommend a firmware
update. The update will make sure your oven is operat-
ing at its maximum efficiency, but should not affect
cooking results or menu settings.
CAUTION: Do not remove the USB until
“Installation Complete” is displayed.
1. When the oven is off or cooling down, insert
the USB. The oven will automatically
detect the USB. Touch “OK” to proceed.
2. Load the firmware:
a. Touch “Update Firmware.”
b. Touch “OK” to confirm the selection.
3. The oven will install each firmware file included
with the update. Once installation is complete,
the oven will display “Installation Complete.”
Figure 25: Inserting USB Device