Page 37 of 58 Pages
6.3 DPU 30 Printer Handling
6.3.1 Setting Paper
If the autoclave is equipped with A DPU 30 printer, follow the
instructions in this paragraph.
1. Press the paper cover open button, and open the paper cover.
Handle the paper cutter carefully not to cut your hand.
2. Set a paper roll as shown in the figure.
3. Close the paper cover by pressing both ends of the cover with the
tip end of the paper emerging from the cutter.
6.3.2 Maintenance
1. Wipe off the soiling on the printer surface with a dry soft cloth with
a weak neutral detergent. After that, wipe the printer with a dry
cloth.
3.
Caution: Never disassemble the printer. Failure to follow this
instruction may cause overheating or burning of the printer or the
AC adapter. Or an electric shock, which may lead to fires or
accidents.
4. Never use the printer in a place of extreme humidity or any place
where it can possibly be splashed by any liquids. If any liquids get
into the printer, it could lead to fire, electric shock, or other serious
accidents.
5. Never touch the thermal head immediately after printing because it
becomes very hot. Make sure that the thermal head is cool before
setting papers or cleaning the thermal head.
6. Power OFF the printer in any of the following cases:
The printer does not recover from an error.
Smoke, strange noise or smells erupt from the printer.
A piece of metal or any liquid touches the internal parts or slot of
the printer.
7. Notes on treatment of thermal papers:
Store the papers in a dry, cool and dark place.
Do not rub the papers with hard substance.
Keep the papers away from organic solvent.
To Next Page
Loading...
