Page 39 of 58 Pages
9. Once a week, use a biological spore test indicator in any load to make
sure sterilization is performed.
10. Make sure that all instruments remain apart during the sterilization cycle.
11. Load the basket loosely to capacity.
7.2 Tubing
Clean tubing and rinse with pyrogen - free water. Ensure both ends of the
tube are open, and free of any sharp bends, twists or kinks.
7.3 Liquids
1. Use only heat- proof glass containers, filled to 2/3 capacity.
2. For Slow exhaust cooling (without air) the glass container should be
covered but unsealed.
7.4 Loading
The loading of goods and instruments is done by means of two stacked
baskets. The baskets are provided with handles for the convenience of the
operator.
There are 2 types of baskets:
1. Baskets that are fully perforated.
2. Baskets that are not perforated except one row of holes adjacent to the
basket’s top. These baskets are intended for waste cycles, to avoid
clogging of the vessel’s drainage pipe by overflowing liquids.
RightWrong
To Next Page
Loading...
