Page 5 of 58 Pages
Note:
If there is any difficulty with this instrument, and the solution is not
covered in this manual, contact our representative or us first. Do not
attempt to service this instrument yourself. Describe the difficulty as
clearly as possible so we may be able to diagnose the problem and provide
a prompt solution.
If the autoclave is equipped with a printer, send along a copy of the last
printout for our inspection. If replacement parts are needed, stipulate the
model and serial number of the machine.
No products will be accepted for repair without proper authorization from
us. All transportation charges must be paid both ways by the owner. This
warranty will be void if the unit is not purchased from an authorized full
service
Tuttnauer dealer.
1.4 Ordering Information
Several items must be specified when ordering the unit from the dealer.
Exact model number (depending on desired chamber size).
Please specify the supply voltage available, 230/380V; 1PH or 3PH.
Temperature scale: Specify Centigrade or Fahrenheit.
Pressure scale: Specify kPa or psi.
1.4.1 Options
Printer option
Hanging temperature control probe for use with liquids, to
be placed directly inside a sample solution.
Cooling option - specify cooling method: with or without
compressed air. Air is used to balance the chamber
pressure during the cooling stage.
1.4.2 Accessories
Basket accessories: A set of two baskets is available for the unit.
The baskets are made of stainless steel wire and have a handle.
The basket allows the operator to load a large quantity of
materials into the chamber.
The pressure scale, printer option and cooling method can be set
up at any time by a technician.
Stainless steel containers: A stainless steel container, for waste
products, is available. This container has vent holes on its upper
part
To Next Page
Loading...
