Page 55 of 58 Pages
Solution
A problem with the printer paper often prevents the operator from changing programs.
To rectify the problem, perform the following:
Turn off the main switch.
Remove the printer paper as described in the Chapter on “Printer Handling”.
At this point the no paper indicator on the printer lights.
Turn the main switch on. The cycle should return to the previous stage.
At this point insert the printer paper, verifying that it is inserted properly.
If the cycle does not return to its former stage, the technician must perform a
memory reset as described in this manual.
After performing a reset, insert the printer paper with care.
7.1 Make sure the paper is mounted in the right way. Only one side of the paper is
printable.
(see para. 6.2, Printer handling)
8.1 Make sure the paper is inserted in the printer.
(see para. 6.2, Printer handling)
8.2 Switch off the machine and switch it back on while pressing the feed button on
the printer. If the printer prints a test printout, the printer is O.K. and there is a
problem with the electronics. Contact your dealer to solve the problem.
If the printer does not print the test printout, there is a problem with the printer.
Contact your dealer to solve the problem.
9.1 Make sure the ‘feed button’ on the printer is not stuck.
Problem
6. You cannot change programs and the
FAIL light remains on.
7. The printer prints, but
nothing is printed on the
paper.
8. The printer does not print.
9. When the machine is
switched on, the printer
feeds paper all the time.
If
To Next Page
Loading...
