Tuttnauer EA - Page 19

Note: At the end of the dry time, the heaters are shut and the compressor continues
working for 20 mins., then stops automatically.
This procedure is aimed at slightly cooling the chamber, which is very hot at the end of
the drving operation.
In order to stop the compressor before the completion of this time, two alternatives are
possible as follows:
a. Open the door of the autoclave.
b. Turn off the main power switch.
PROGRAM 3; LIQUIDS
For distilled water, solutions, medicines and other liquid preparations
in closed bottles or flasks.
Nominal parameters default settings
e Sterilization temperature :250°F (121°C).
e Sterilizatin time : upto 30 minutes.
Operations sequence:
e Heating and sterilization as in Program 1, but with temperature and time specific
to this program.
e Slow exhaust, heating 1s stopped and steam is let out of the chamber at a slow
rate until zero pressure 1s reached.
PROGRAM 4: ACCESSORY (DRY ONLY)
This accessory program allows the user to add dry time after the sterilization time is over.
STAND- BY HEATING MODE
The autoclave provides an option of heating the chamber in stand - by mode between cycles
with a very low power in order to reduce total cycle time. (1.6% of the total power only).
The autoclave will turn off automatically if the interval between sterlization cycles is more
than 2 hours.
The stand-by mode is an integral feature on all EKA models.
The company trained technician can cancel this feature on EKA models.
18