Tuttnauer EA - Filling the Water Reservoir

4.2
FILLING THE WATER RESERVOIR
1. Remove the water reservoir cover. Pour distilled water into the reservoir through
the opening on top of the autoclave until it reaches the base of the safety valve
holder.
It is recommended to use water having the following characteristics:
1. Electrical conductibility lower than 15 microsiemens.
2. Chlorides content, less than 4 pp.m.
3. PH 6.5-8.
Caution:
Under no circumstance should water be filled above the safety
valve holder.
Use distilled water only . Tap water may block the hole of the air trap. This causes
air pockets which prevent the temperature from rising. It is essential that from time
to time during the sterilization period , a spray of steam should escape, causing a
hissing sound. If no steam is evident, follow instructions for air trap jet cleaning
procedure on page 30.
DAT FOR SEE AP に に GAY
TS
|
о
! sen s“ + >
eo
TP
Te
DO
ー
m
a
ddl
ler
Sides
y
EN
eur
A
-
ti
~
一
、
pe
APE
a!
Lee
IE O if
21