Tuttnauer EA - How to Reset the Cycle Counter

At the end of the cycle a buzzer will ring for approximately 5 seconds. the START
| light then switches OFF. The exhaust valve is opened to prevent formation of a
vacuum, if the door is not opened immediately. In the event of program failure, an
exhaust valve is opened and a continuously buzz will sound for 5 seconds followed by
| an interrupted buzz for 7 seconds.
| 9. Open the door and unload the sterilized material from chamber.
10. The sterility of instruments processed in unwrapped cycles cannot be maintained when
| | exposed to non-sterile environment.
HOW TO RESET THE CYCLE COUNTER
To reset the cycle counter proceed as follows:
| 1. Press the STOP key a few times, till the CODE 102 appears on the display.
| 2. Press the UP key (8) up to CODE 134
3. Press any Key to continue.
| The counter is now reset.
. e RT TIT EN STICA CORE TI ANECA AMA
- - - - ーー