Tuttnauer EA - Heater Replacing Procedure

7.8 HEATER REPLACING PROCEDURE
Caution :
power source and that there is no pressure in the autoclave chamber.
个 Before starting, be sure that the electric cord is disconnected from the
1. Dismantle the autoclave cover.(page 41)
し
っ
. Remove the heater tightening bolts (1)
3. Release the two terminal wires from the heating element.
4. Make sure the heater strap 1s well tightened to the autoclave body, so as to
ensure a proper heat dissipation for the heat element.
5. Replace the autoclave cover.
6. Test all the autoclave cycles .
ù
「
1
y
ーー
ニー
ーーーーー
ーー
/
^
.
|
|
:
B
ーー
5
+=
=
а
!
n
、
TEN
over
eos
a
44
ο
=
rå
rote
ros
~