Tuttnauer EA - Air Trap Jet Cleaning Procedure 3]

6.4 AIR TRAP JET CLEANiNG PROCEDURE
(Located in the water reservoir.)
Caution:
Before proceeding, make sure that the electric cord is disconnected and
that there is no pressure in the autoclave.
Allow the instrument to cool and the pressure to drop to 0, before cleaning the jet.
1. Remove the water reservoir cover.
2. Clean the hole of the jet, by manipulating the air trap wire back and forth.
3. In case it is necessary to replace the air trap jet, use teflon tape.
31