116
ATTENTION! Before closing the hood, make sure it will not
entrap anything and the hood latch is securely xed in the holder.
When closing the hood, check that the lock works properly.
Avoid free falling of the hood from a large opening angle.
Wind-screen wipers, water pumps for the washer
To ease washing the windshield manually, wiper blades must
be placed in xed position away from the windshield.
In cold seasons, before switching on the windshield wipers,
make sure the wiper blades are not frozen to the windshield.
Windshield wipers should not be turned on when the windshield
is dry. Keep the wiper blade rubber out of contact with fuel and oil.
While operating, make sure the windshield wipers work properly
and their parts are securely xed. Periodically clean the windshield
and rubber edges of the wiper blades from dirt and oil.
During seasonal service, keep the windshield wipers on for
15–20 minutes. Wiper blades must be placed in xed position away
from the windshield. The wiper blade arm of the rear window must
be detached.
After 18–24 months of operation replace wiper blades or their
rubber edges if necessary.
Replacement of wiper blades of windshield wipers
To replace wiper blades of windshield wipers perform the fol-
lowing steps:
– lift the arm of the windshield wiper from the windshield or
the rear window;
– rotate the wiper blade about its axis of rotation and place it
nearly perpendicularly to the lever; prior to this step release the wiper
blade lock by pressing the tab on the adapter between the wiper
blade and the lever; dismount the wiper blade from the lever.
A new wiper blade is installed in the reverse order.
Note. Installation of frameless wiper blades is possible.
Washer reservoir 2 (Fig. 3.28) is lled with clean water
(in summer) or a special nonfreezing uid (in winter).
To drain water from the washer reservoir pull out the washer
reservoir and disconnect electric wiring and tubes from the washer.
To Next Page
Loading...
