189
5. Mixing (adding) of engine oils of different brands and dif-
ferent manufacturers is not allowed.
When changing the oil brand or manufacturer, ush the engine
lubrication system.
6. Mixing “Litol-24” grease with “Lita” substituting grease is
allowed in any proportions. When using other substitutes wash
the unit with kerosene.
7. Mixing the brake uids “Rosa”, “Rosa-3”, “RosDot”, “Tom”,
“Rosa Dot-4” is allowed in any proportions.
CHAPTER 10. SPECIAL TOOLS
AND APPLIANCES
Each new vehicle, delivered from the manufacturing plant, is
equipped with a set of tools and appliances according to the list
applicable to the vehicle.
A jack (Fig. 10.1 or 10.2) is applied for lifting vehicle wheels
when servicing or repairing. Carrying capacity of the jack in
Fig. 10.1 is 2 tons, that of the jack in Fig. 10.2 is 1 ton. The highest
lifting point of the jack in Fig. 10.1 is 410 mm, that of the jack in
Fig. 10.2 is 380 mm.
WARNING! If defective or installed improperly, the jack can
cause injuries or motor vehicle damage. It is strictly forbidden
to carry out any work with the motor vehicle if it stands only
on the jack.
For jacking up the wheel with jack shown on Fig. 10.1,
proceed as follows:
1. Brake the vehicle with the parking brake, shift into the rst
or reverse gear of the gearbox, making sure that the transfer case
gear lever is not in the neutral position. As required, put wedges
under the wheel, which is opposite to the jacked up wheel.
2. Install the jack on a level ground under the axle shaft sleeve.
3. Untwist internal jack screw 3 as high as the clearance between
the axle shaft housing and the ground allows.
To Next Page
Loading...
