EasyManua.ls Logo

UAZ PICKUP - Interior Rearview Mirror

UAZ PICKUP
208 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
96
— the lamp switches on and off automatically, when opening
or closing the door. The interior lamp is on if any of the motor vehicle
doors are open. After closing all the doors, the lamp lights for 25 s
(depending on the conguration), and then smoothly goes off for 2 s.
— the lamp is on until it is switched off.
When switch 2 is in mid-position, the lamp switches off.
Lamp of the luggage compartment turns on (Fig. 9.45) when
opening the tail gate.
The control of the interior lighting units (“gentle” light) with a
smooth change of brightness for 2 s when turning on and off the
interior lighting lamps is enabled:
– when opening any of the side doors;
– when turning on and off the “Security” mode via a radio
channel of the remote control panel;
– when receiving “Find motor vehicle in unlighted parking
area” command via remote control panel;
– when turning on the ignition, after all the doors are closed
while the lamp is still in ‘ON’ position;
– 25 s after all the side doors are closed, if during this period
the ignition was not turned on, any of the side doors were not open,
the “Security” mode was not switched on via a radio channel of
the remote control panel;
– in 10 minutes when one or more side doors are constantly
open (if during this period all the side doors were not closed, the
tail gate was not opened or closed, the ignition was not turned on).
The lighting turns on when the ignition is turned off and the doors
are open, and also for not more than 25 s after all the doors are closed.
When the ignition is turned on, the interior lighting is on only
if at least one side door is open.
Interior rearview mirror (Fig. 3.25)
Interior mirror is adjusted by pivoting around its joint.
ATTENTION! In order to avoid blinding by headlights of
vehicles traveling behind during night driving conditions, it is
necessary to change the tilt angle of the mirror with a lever posi-
tioned below the mirror.

Table of Contents

Related product manuals