193
Release the bow and front springs by putting wooden spacers
between the frame and the axles.
The preserved vehicle should be located in a clean ventilated
room with a relative humidity of 40–70% and temperature not less
than +5 °C.
It is forbidden to keep the motor vehicle and poisonous sub-
stances (acids, alkali, etc.) together.
Maintenance of a stored vehicle
Carry out the motor vehicle maintenance every two months.
Do the following:
1. Carefully inspect the vehicle from the outside.
2. Screw off the spark plugs and turn the engine crankshaft
with the starter motor (for 3–5 sec) after shifting into the rst gear
of the gearbox and into the reduction gear of the transfer case.
Disconnect the power wires from the ignition coils in advance.
Once a year, ll the engine cylinders with 30–50 g of the engine
oil by turning the crankshaft.
3. Clean the damaged areas from corrosion and grease and
paint them.
4. Turn the steering wheel to both sides 2–3 times.
5. Check the parking brake and the pedal brake, the clutch, the
throttle drive and lighting switches.
6. Check the working uid level in the reservoirs of the brake
master cylinder. As required, top up to normal.
7. Check the electrical equipment instruments.
8. Check the tools and accessories. Wipe and lubricate them
as required.
9. Check the tires and other rubber details.
10. Eliminate any detected defects during inspection.
Depreservation
1. Remove greased paper from the details and preservation
grease, wash the details with kerosene or unleaded gasoline. Thor-
oughly remove the grease from the details that can contact rubber
details or painted surfaces. Thoroughly wash the spark plugs in
unleaded gasoline.
To Next Page
Loading...
