70
White indication opposite to each sensor means that the sensor
is operating and there are not any hindrances for driving at a dis-
tance up to 90 cm from the surface of the bumber. Green indica-
tion means that a hindrance is detected for driving at a distance
90–60 cm from the surface of the bumper it is recommended to
signicantly reduce the speed.
Yellow indication means that a hindrance for driving is detected
for driving at a distance of 60–30 cm from the surface of the bumper
it is recommended to drive with special precaution or stop.
Red indication means that a hindrance is detected for driving
at a distance less than 30 cm, it is recommended to stop.
Numerical information about actual distance to the nearest
hindrance can be displayed on this screen (see MMS settings).
This system is auxiliary and it does not allow to fully avoid
the motor vehicle contact with hindrances. Safe parking system
is not responsible for the motor vehicle damages.
CAMERA, REAR VIEW
Rear view camera is embedded into the licence plate lamp
lining and is intended to assist the driver when driving in reverse,
it displays the information about the situation on the road behind
the motor vehicle on the screen. Rear view camera displays on
the screen of multimedia system guide static (driving corridor)
or dynamic (depending on the steering wheel angle of rotation)
parking lines and the view behind the motor vehicle Fig. 3.17.
Multimedia system draws the dynamic parking lines, receiving
the signal from the steering wheel angle of rotation sensor and
imposes them on the video. Dynamic parking lines are moving
synchronously and in the same direction as the steering wheel.
Rear view camera switches on when the gearbox lever is in
‘back run’ position.
Distance line (red) Fig. 3.17.
This line shows the distance behind the motor vehicle: the line
is located in 0.6 m from the spare wheel plane.
To Next Page
Loading...
