159
Check the uid level in the tank simultaneously with the alarm
level sensor, which can be done by uncapping the tank (if the igni-
tion is on, the warning light should appear on the dashboard).
WARNING! If the motor vehicle is equipped with ABS and
the brake uid level is reduced lower than MIN mark or air enters
the system, contact a service station, as this failure needs to be
inspected with additional diagnostic equipment.
Bleed the brake system, if the motor vehicle is not equipped
with ABS and ESP.
Check the brakes hoses. If cracks appear on the outer side of
the hoses, replace them.
If brakes pipes have corrosion, replace them.
Anti-lock braking system. Depending on the congura-
tion motor vehicles can be equipped with the anti-lock braking
system (ABS). ABS prevents the wheels from locking up while
braking, which keeps the initial motion trajectory and minimum
braking distance. However the motor vehicle braking distance
can be increased when breaking on roads with soft surface
(gravel, sand, unrolled snow) compared to lock braking in the
same conditions.
ABS braking starts from the speed of 10 km/h and is accom-
panied by slight pulsation of the brake pedal and typical noise of
ABS actuators.
Illuminating of ABS signal
of malfunction (except for
self test mode when cycling the ignition,as well as ABS switch-
ing off at switching on of the rear axle differential lock) indicates
a system malfunction. Despite the fact that it does not affect the
work of the hydraulic brakes drive, it is recommended to contact
UAZ service station to eliminate the problem.
To Next Page
Loading...
