57
It is prohibited to operate the system if there is a possibility
of the ingression of corrosive liquids, acids, water, oil and petrol
in the CU, DSDM and RCP.
System functions:
– central locking and unlocking with the key;
– central door locking and unlocking from the inside of interior;
– door locking and unlocking from the RCP depending on the
motor vehicle package;
– side door window lifting and lowering control;
– outside rear view mirror position adjustment control;
– interior lighting control (polite lighting) depending on the
motor vehicle package;
– intrusion alarm system;
– motor vehicle search in an unlighted parking place;
– ‘Panic’ signalling and prompt alarm;
– system trouble diagnosis through the motor vehicle data link
connector.
Operation procedure with the control system
Door locks locking and armed mode
switching on using the RCP
To lock door locks and switch armed mode ON it is necessary
to short press button 3 (Fig. 3.13) on the RCP. All side door locks
and the lock of the T/gate are locked, the system switches over to
the armed mode that is indicated by a single blink of the T/signals
and a slow blinking of the signal device system in the cluster
.
If any door, the cowl or the T/gate are opened when switching
armed mode on, the T/signals blink three times and a single horn
is given. In order to include the opened areas into the security zone
they must be closed.
Door locks unlocking and armed mode
switching off using the RCP
To unlock all door locks and the T/gate lock and switch armed
mode OFF it is necessary to short press button 2 on the RCP.
Switching armed mode OFF is accompanied by a double blink
To Next Page
Loading...
