77
Pressing of key “Set +” for more than 0.5 s leads to stepwise
increase of the set speed threshold by 10 km/h each 0.5 s, and the
highest threshold is limited to 150 km/h.
Pressing of key “Set -” for more than 0.5 s leads to stepwise
decrease of the set speed threshold by 10 km/h each 0.5 s and the
lowest threshold is limited to 40 km/h.
Single pressing of keys “Set +” or “Set -” in overtaking mode
(item 4) will set the current speed as the threshold.
At long or single pressings of “Set -” key, the set threshold
cannot be xed lower than the current speed of the motor vehicle.
4. Overtaking mode.
If the accelerator pedal is pressed to 95% of its stroke, OSL
function is deactivated and the vehicle speed increases without
limit.
Subsequent activation of OSL function occurs automatically
at pressing the accelerator pedal less than 95% of its stroke
and decreasing the motor vehicle speed below the preset speed
threshold.
5. Deactivation.
Function OSL is deactivated by pressing key “CAN”. The speed
threshold value is saved in the nonvolatile ECU memory.
6. Resumption.
Resumption of AC function is possible by pressing key “RES”
under the following conditions:
– the speed threshold value different from zero is saved in the
control unit memory;
– the current speed is lower than the saved threshold value.
If the current speed is higher than the threshold, the pressing
of key “RES” is ignored.
To Next Page
Loading...
