Ultimaker S8 - Page 8

7
UltiMaker S8 Installation and user manual
2. RFID Frequency Band and Maximum field strength
This device operates in the ISM frequency band at 13.56 MHz and complies with the Radio Equipment Directive
(RED) 2014/53/EU under ETSI EN 300 330. The following table outlines the frequency ranges and maximum power:
Frequency Band (MHz) Usage Max Output Power (EIRP)
13.553 – 13.567 Indoor and outdoor use* 1.656 μA/m at 10 meters
This device operates in the ISM frequency band at 13.56 MHz and complies with the Radio Equipment Directive
(RED) 2014/53/EU under ETSI EN 300 330.
* Note: The UltiMaker S8 is not intended for outdoor use.
USA
FCC Supplier’s Declaration of Conformity
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own expense.
FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
FCC RF Exposure Warning:
This product complies with the FCC radiation exposure limits set forth for an uncontrolled environment
with a minimum 8 inches spacing requirement between the transmitter and a person’s body during
wireless modes of operation.
Canada
Innovation, Science, and Economic Development Canada Compliance Statement
English
This Class A digital apparatus complies with Canadian ICES-003. This device contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired
operation of the device
Caution: The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.
Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 22 cm between the radiator and your body.