Ultimaker S8 - Personal Protective Equipment; Regulatory Information

6
UltiMaker S8 Installation and user manual
1.4 Personal protective equipment
The following items are recommended for safely working with UltiMaker S series products,
particularly during maintenance:
• Tweezers. Required for safely removing material residue from the nozzle tips.
• Pliers. When performing the hot and cold pull procedure to clean the print cores, use pliers to hold the filament.
This prevents hand injury in case the material breaks.
• Thermal gloves. Recommended when cleaning the nozzle, as the nozzle will be hot during these procedures.
• Protective gloves. Recommended when removing brims or support structures from the printed parts, or when
using tools to remove objects from the build plate.
• Safety glasses. Recommended when removing support structures, performing certain post-processing tasks, or
in other situations with an increased risk of injury.
Note: Situations where personal protective equipment is recommended are referenced throughout this user
manual, or visit ultimaker.com/s-series-safety-compliance.
1.5 Regulatory information
This section contains regional regulatory and compliance notices.
Tip: See the compliance label at the back of the printer for regional certification labeling or visit
ultimaker.com/s-series-safety-compliance for additional compliance information.
EU and UK
EC Declaration of Conformity
The UltiMaker S8 is compliant towards the essential requirements and other relevant provisions of:
• Machinery Directive 2006/42/EC,
• EMC Directive 2014/30/EU,
• RED 2014/53/EU,
• RoHS Directive 2011/65/EU,
• WEEE Directive 2012/19/EU
RED regulatory notices
1. Wi-Fi Frequency Bands and Maximum RF Output Power
This device operates on both 2.4 GHz and 5 GHz Wi-Fi frequency bands in compliance with the Radio Equipment
Directive (RED) 2014/53/EU. The following table outlines the frequency ranges and maximum power:
Frequency Band (MHz) Usage Max Output Power (EIRP)
2412 – 2484 Indoor and outdoor use* 15.14 mW (11.80 dBm)
5150 – 5725 Indoor use only 18.62 mW (12.70 dBm)
Wi-Fi regulatory notices:
• 2.4 GHz Wi-Fi: Allowed for indoor and outdoor use across all EU countries.
• 5 GHz Wi-Fi: 5150 – 5350 MHz: Restricted to indoor use only to prevent interference with
satellite and radar systems.
* Note: The UltiMaker S8 is not intended for outdoor use.