Ultimaker S8 - Maintenance; Update the Firmware; Material Handling and Storage

25
UltiMaker S8 Installation and user manual
5. Maintenance
The UltiMaker S8 is designed for high accuracy and high speeds, with a future-proof new electronics
platform. Learn how to keep your printer up to date and perform regular preventive maintenance to ensure
your printer remains in optimal condition.
5.1 Update the firmware
Periodically, a new firmware version is released. To ensure that your UltiMaker S8 is equipped with the latest
features, it is recommended to keep the firmware updated.
Note: The first UltiMaker S8 printers are shipped from the factory with a blocking firmware. The printer must
first be updated via USB; follow the instructions below.
Update over the network
If the UltiMaker S8 is connected to a network, it automatically checks for available firmware updates. When
new firmware is available, the printer will prompt you to download and install it via the touchscreen interface.
Alternatively, check for updates manually in the Options menu: Maintenance → Update firmware.
Note: Do not power off the printer during the firmware installation.
Update using a USB stick
If the UltiMaker S8 is not connected to a network, you can update to the latest firmware via USB.
The firmware files are found on the UltiMaker website:
1. Navigate to ultimaker.com/firmware, and select your printer.
2. Download the firmware file and store it in the root directory of your USB stick.
3. Insert the USB stick into the USB port of the printer.
4. In the Options menu, go to Maintenance → Update firmware and select the new firmware.
Note: Wait for the firmware installation to complete. Never remove the USB stick or power off the printer
during the installation.
5.2 Material handling and storage
Opened material spools must be stored properly when not in use. If material is stored incorrectly, its quality and
usability may be affected.
The storage temperature ranges for UltiMaker materials are as follows:
• PLA, Tough PLA, PETG, PET CF, PPS CF, CPE, CPE+, PC, Nylon, Nylon CF Slide, PP, TPU 95A, and
Breakaway: -20 °C to +30 °C
• ABS: +15 °C to +25 °C
• PVA: +10 °C to +30 °C
Tip: Normal office conditions / room temperatures are recommended.
Furthermore, a relative humidity of below 50% is recommended for PVA, Nylon, Nylon CF Slide, and TPU 95A. If
these materials are exposed to higher humidity, the quality of the material can be affected.