37
Important: Deleted systems cannot be restored. You must re-enter them.
Programming Sites MESL
This section covers settings that apply to trunked radio site. You must program at least one site for each trunked radio system. When
you program multiple sites, all sites share the same channel groups and channels within the system.
Note: You can only program one site in an EDACS SCAT and LTR system.
Setting the Site Name ME
Each site name can be up to 16 characters. Abbreviate as necessary to fit. The site name alternates with the Channel group when
the scanner stops on a channel.
The default site names include the following letter in the 16th position to indicate the system type:
MS1: Motorola 800 MHz Type I Standard
MS2: Motorola 800 MHz Type II Standard
MP1: Motorola 800 MHz Type I Splinter
MP2: Motorola 800 MHz Type II Splinter
P25: APCO 25 (all bands)
M92: Motorola 900 MHz
MV2: Motorola VHF
MU2: Motorola UHF
EDW: EDACS Wide
EDN: EDACS Narrow
Following these steps to change the system name.
[MENU]
Program System ◙
Select a trunked system ◙
Edit Site ◙
Select a Site ◙
Edit Name ◙
To enter a letter, turn the Scroll Control until the character you want appears. To enter a decimal point, press [.No] . To move the
cursor to the left, press [4]. To move the cursor to the right, press [6].
To clear a character, press [.No] twice. To clear all characters, press [.No] 3 times.
To accept an entry, press [E
YES] or ◙.
Setting the Site Quick Key MESL
[MENU] Program System ◙
Select a trunked system ◙
Edit Site ◙
Select a Site ◙
Set Quick Key ◙
After selecting this option, select any number from 0-99 to assign the system to a quick key or press [.No] to assign the system to
no quick key, then press
◙.
Notes:
To Next Page
Loading...
Need help?
General
