42
Select a Group ◙
Edit Name ◙
Follow these steps to enter/edit the group name.
1. The current name displays with the first character of the name highlighted.
2. Rotate the Scroll Control to select a new first letter. Press [6] to move one character to the right. Repeat the Scroll Control
action to change the character. To move one character to the left, press [4].
3. Repeat Step 2 until you have entered the system name. Then press
◙ to accept the setting.
Notes:
• Each group name can be up to 16 characters. Abbreviate as necessary to fit.
• The group and system (for conventional, SCAT, and LTR systems) or site (for Motorola and EDACS systems) name
alternate in the top line of the display when the scanner stops on a channel.
• Press [.No] twice to delete the current character.
• Press [.No] three times to clear the entire alpha tag.
Editing Channels MECL
Once you create a channel group, store channels in that group. See “Programming Channels” for specific channel options.
Locking Out Channel Groups MECL
[MENU] Program System ◙
Select the existing system ◙
Edit Group ◙
Select the existing group ◙
Set Lockout ◙
This setting determines whether the scanner will scan this group of channels. Select your setting, then press
◙.
Lockout - the group is not scanned.
Temporary L/O - the group is not scanned for this session. The L/O is cancelled when you cycle power.
Unlocked - the group is scanned. The default setting is Unlocked
Deleting Channel Groups MECL
[MENU] Program System ◙
Select a system ◙
Edit Group ◙
Select a channel group ◙
Delete Group ◙
Confirm Delete?
Yes=”E” / No= “.”
To Next Page
Loading...
