46
This setting controls the modulation method used for the channel. In most cases, if you leave this set to Auto, the scanner
automatically selects the correct modulation type for the channel you are programming.
Setting Channel Attenuation C
[MENU] Program System ◙
Select a conventional system ◙
Edit Group (existing site) ◙
Select a Channel Group ◙
Edit Channel ◙
Select a channel ◙
Set Attenuator ◙
This setting controls whether the scanner attenuates signals on this channel. Select your setting, then press
◙.
On - the channel is attenuated by about 20 dB.
Off - the channel is not attenuated. The default setting is Off
You can also toggle this setting by holding on the channel and pressing
◙ then [7/ATT] within 2 seconds.
Setting Channel Priority C
[MENU] Program System ◙
Select a conventional system ◙
Edit Group ◙
Select a channel group ◙
Edit Channel ◙
Select the channel ◙
Set Priority ◙
This setting controls whether the scanner treats the channel as a priority channel while scanning. Select On or Off, then press
◙.
On - when you turn on the Priority feature, the channel will be scanned every 2 seconds.
Off - the channel will not be treated with priority. The default setting is Off
Setting Channel Alert MECL
[MENU] Program System ◙
Select a system ◙
Edit Group ◙
Select a channel group ◙
Edit Channel ◙
Select the channel ◙
Set Alert ◙
Off - the scanner does not alert you when the channel becomes active.
To Next Page
Loading...
Need help?
General
