63
There are four setting conditions that can be set to result in alerts:
• A speed setting greater than zero with no direction entered. This results in an alert based only on speed in any direction.
• A speed setting grater than zero with a specific direction entered. This triggers an alert when the speed is exceeded but only
in the specified direction.
• Speed is equal to zero and a direction is entered along with a location. This setting is used for a dangerous intersection alert.
• Speed is set to zero and no direction is entered but only location. This is a point of interest alert.
By pressing [FUNC] + [GPS] you can next choose from a setting for Speed, Intersection, or Point of Interest.
By pressing & holding [GPS], you can select a location type and store current location data.
The following table shows the attributes available for each category. Note that some options are different for a specific location type.
Refer to the information that follows to set those specific attributes.
Menu Option POI Dangerous
Xing
Dangerous
Road
New Location
● ● ●
Edit Name
● ● ●
Set Type (edit)
● ● ●
Set Alert Beep
●
Set Alert Volume
● ●
Set Location Info
● ● ●
Set Heading
● ●
Set Range
●
Set Speed
Limit
● ●
Set Lockout
● ● ●
Delete Location
● ● ●
Setting the Options
[MENU] Program Location ◙
Select your location type ◙
New Location ◙
The scanner assigns a sequentially created number to your new Point of Interest.
Edit Name ◙
Use the Scroll Control and ◙ to change the name the scanner assigns to the POI to one you prefer.
Set Type ◙ At this level you have an opportunity to reassign or edit the location type you first selected and set the location
to either one of the other types or change the data in an existing location.
This switch also associates a new Alert Tone to the location. You can still associate a different sound level.
Set Alert Beep ◙ Choose from Off, no tone sounds or Alert 1 to Alert 4.
Set Alert Volume ◙ select from 15 sound levels, plus Auto and Off. As you rotate the Scroll Control the Alert tone set
through the POI menu is played louder and louder. Press
◙ to select one. You can also select no sound or Auto, a level that is the
same setting as your volume control setting. Note: First choose POI as your type so that you can then choose the desired Alert Beep.
Set LocationInfo ◙ Input the latitude and then the longitude.
To Next Page
Loading...
