41
[Picture of a circle with latitude/longitude labeled in the middle and a radius drawn and labeled range.]
Adjust P25 Level MEL
[MENU] Program System ◙
Select a trunked system ◙
Edit Site (current) ◙
Select a site ◙
Adjust P25 Level ◙
This setting determines some site-specific parameters for digital channels. In most cases, setting this to Auto provides the best
performance. However, you can also manually set the digital decode threshold. This setting affects all channels in the current site.
See “Optimizing P25 performance” on Page XX
Auto - the scanner automatically adjusts the digital decode threshold to match the transmission you are hearing when it receives a
strong signal and has a high decode rate.
Manual - lets you manually adjust the digital decode threshold. To manually adjust the P25 level, select Manual.
Default - sets the digital decode threshold to the default value. Use this setting to return to the value that usually provides
adequate performance. This is handy is you have manually adjusted the value to a setting that prevents proper decoding.
Note: This setting has no effect on how these sites are received.
Deleting Sites ME
[MENU] Program System ◙
Select a trunked system ◙
Edit Site ◙
Select a site ◙
Delete Site ◙
Confirm Delete?
Yes=”E” / No= “.”
Important: Deleted sites cannot be restored. You must re-enter them.
Programming Channel Groups MECL
Setting Up a Channel Group MECL
[MENU] Program System ◙
Select a system ◙
Edit Group ◙
New Group ◙
The scanner creates a group with a default name of Group n. n increments by one for each new group you create within a system.
Editing a Channel Group Name MECL
[MENU] Program System ◙
Select a system ◙
Edit Group ◙
To Next Page
Loading...
Need help?
General
