39
Auto - the scanner uses the default modulation for the frequency band.
FM - the scanner uses FM (frequency modulation) for the frequency band.
NFM - the scanner uses narrowband FM for the frequency band.
Note: The default setting is Auto.
This setting controls the modulation method used for the frequency band. In most cases, if you leave this set to Auto, the scanner
automatically selects the correct modulation type for the system you are programming.
Setting Site Attenuation MESL
Enable Attenuation if you are near strong signal sources. Attenuation can help reduce interference and desensitization that strong
signals create. You can also turn this setting on or off by holding on a trunked system, then pressing
◙ + [7/ATT].
[MENU]
Program System ◙
Select a trunked system ◙
Edit Site ◙
Select a Site ◙
Set Attenuator ◙
Off - the attenuator is off.
On - site frequencies are attenuated by about 20 dB.
Setting Site Lockout MESL
[MENU] Program System ◙
Select a system ◙
Edit Site ◙
Select a site ◙
Set Lockout ◙
Select from the following choices ◙
Unlocked - the system is scanned when its quick key is enabled.
Temporary L/O - the system is locked for this session.
Locked - the system is not scanned.
Setting Site Hold Time MESL
[MENU] Program System ◙
Select a trunked system ◙
Edit Site ◙
Select a site ◙
Set Hold Time ◙
This setting controls how many seconds the scanner looks at a site before moving to the next unlocked site or system. Using the
number keypad, enter a value from 0-255, then press
◙ to save the setting.
Notes:
To Next Page
Loading...
Need help?
General
