Unipulse F331 - 6 External Input;Output Signals; Connector Pin Assignments; External Input Signals; Hold;Judge <Edge Input

22
6 EXTERNAL INPUT/OUTPUT SIGNALS
22
EXTERNAL INPUT/OUTPUT SIGNALS
Chapter
6
6-1. Connector pin assignments
6-2. External input signals
IN1: Hold/Judge
IN2: Digital zero
■Hold/Judge <edge input>
For hold signal, please use hold mode.
When the hold mode is OFF, it operates as a judgment signal of comparison timing.
However, it is unrelated when comparison timing condition is ALWAYS or NZ.
■Digital zero <edge input>
The digital zero works to zero the indicated value.
6 EXTERNAL INPUT/OUTPUT SIGNALS
Signal input/output
678910
IN1 IN2 OUT1 OUT2
78910
COM
6
terminal block
OFF
Hold ON
ON
OFF
Hold OFF
ON
OFF
Judge ON
ON
OFF
Judge OFF
ON
OFF
ON
Pulse width 50mSec or more