Unipulse F331 - Continuous Transmission Formats; Setting Value LOCK; Calibration Value LOCK

65
7 OPTION
65
OPTION
Chapter
7
■Continuous transmission formats
- Transmission format 1
- Transmission format 2
■Setting value LOCK/ Calibration value LOCK
This function to avoid change of setting values and calibration values.
0: OFF (Unlocked state)
1: ON (Locked state)
*1 O : Overload (LOAD, OFL)
H : Under a hold/ Under a judgment
Order of priority: H > O
*4 H : HH limit ON
L : LL limit ON
G : HH limit and LL limit OFF
N : HH limit and LL limit ON
F: Comparison OFF
Order of priority: N, F > (H or L) > G
*2 G : OK ON
N : NG ON
F: Comparison OFF
Order of priority: F > (G or N)
*5 N : Near zero OFF
Z : Near zero ON
*3 H : HI limit ON
L : LO limit ON
G : HI limit and LO limit OFF
N : HI limit and LO limit ON
F: Comparison OFF
Order of priority: N, F > (H or L) > G
*6 Decimal place
0: None
1: 0.0
2: 0.00
3: 0.000
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19
GS ,*1 *2 *3 *4,, ,,
±
*5 ,
20 21
Sign
+ or -
5-digit linked with indicated value
+
decimal point
Delimiter
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
W T *1 *2 *3 *4 ±
Sign
＋ or －
*5
SOH STX ETX BCC
Sign
＋ or －
±
*6
22 23
00
5-digit linked
with indicated value
5-digit not linked
with indicated value
BCC calculation target
Each ASCII code of SOH, STX, and ETX
SOH: 01
STX: 02
ETX: 03
BCC calculation method
Each code targeted for BCC calculation is
expressed in hexadecimal notation, and the result
of XOR with all data enters BCC.