Unipulse F331 - Setting Value LOCK; Calibration Value LOCK

57
7 OPTION
57
OPTION
Chapter
7
* Status 2 (weighing condition)
"1" when each status is ON.
* Status 3 (weighing condition)
- Decimal place: Shows decimal place.
* Linked with indicated value, Not linked with indicated value
■Setting value LOCK/ Calibration value LOCK
This function to avoid change of setting values and calibration values.
0: OFF (Unlocked state)
1: ON (Locked state)
Decimal place
Bit No.
1 0
None 00
0.0 01
0.00 10
0.000 11
Under a hold/ under a judgment
NZ
Undefined
LL
LO
OK
HI
HH
1514131211109876543210
Undefined
Undefined
Calibration value LOCK
Setting value LOCK
Undefined
Decimal place
1514131211109876543210
1514131211109876543210
Indicated value data
Address N