Unipulse F331 - Command Communication Formats

60
7 OPTION
60
OPTION
Chapter
7
■Command communication formats
- Read the linked with indicated value (sign, 5-digit, decimal point)
- Read the not linked with indicated value (sign, 5-digit, decimal point)
- Status 1
For transmission formats, see "■Continuous transmission formats" on page 65.
Attention
About the timing for continuous transmission
According to the communication baud rate setting, the continuous
transmission intervals in the case where any of the communication modes
from 1 and 2 is selected are as follows:
Communication baud rate Continuous transmission interval
38400 bps 100
times/sec.
19200 bps 50 times/sec.
9600 bps 25 times/sec.
4800 bps 12 times/sec.
2400 bps 6 times/sec.
1200 bps 3 times/sec.
Point
Host
F331
RA
＋
010 00
.
RCRA
0 fixed
Delimiter
Host
F331
RB
＋
010 00
.
RCRB
0 fixed
Delimiter
Host
F331
RC 000 000
RCRC
Delimiter 0
+LOAD
-LOAD
OFL2
OFL1
HH
LL
Calibration error No.
0: OFF 1: ON
0: OFF 1: ON
0: OFF 1: ON
0: OFF 1: ON
0: OFF 1: ON
0: OFF 1: ON
F331 error No.