56
7 OPTION
56
OPTION
Chapter
7
* Status 1 (abnormal condition)
- OFL1, OFL2, -LOAD, +LOAD: "1" when each error occurs.
- Calibration processing condition: "1" during calibration.
- Calibration error: Shows the error No. of the calibration error that has
occurred.
"0" means that no calibration error is given.
Bit No.
Cal. err 7 6 5 4
0 0000
1 0001
2 0010
3 0011
4 0100
5 0101
6 0110
7 0111
8 1000
9 1001
The address number used on a message is a relative address.
The relative address is calculated by the following equation.
Relative address = Last 4 digits of address No. - 1
For example, it is 0014 (0x0E) when holding register 40015 is designated.
Point
Undefined
Undefined
OFL1
OFL2
-LOAD
+LOAD
Undefined
Calibration processing condition
Calibration error (0 - 9)
Undefined
1514131211109876543210
To Next Page
Loading...
