73
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
PC-E0 Check Digit
Check Digit specifies whether the check digit should be transmitted at the end of the scanned
data or not. Default = On.
UPC-E0 Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of the
scanned data, but the unit can be programmed so it will not transmit it. To prevent transmission,
scan Off. Default = On.
UPC-E0 Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-E data.
Default = Off for both 2 Digit and 5 Digit Addenda.
To Next Page
Loading...
