Unitek DVR-404 - System Parameter Setting; Communication over Network or Serial Port

To Next Page

To Previous Page

103

4 & 8 & 16 Channel DVR Operation manual Revision 1.0

4.5.2 System parameter setting

* Right parts on System parameter setting window is same form as Main menu used in DVR

system. Users can change DVR system parameter by entering each menu.

* Main menu description

* File ->Open: Read to display saved parameter values from DVR system.

1. File ->Save: Click to save setting parameter values as file.

2. File->Close: Click to close program

3. System parameter-> Read parameters from DVR: Derive to display setting

parameter values

4. System parameter-> Write parameters to DVR: Transfer to save setting

parameters of DVR.

5. System parameter->Default value setting: Initialize parameters values.

6. Communication->Network: Communicate data through network.

7. Communication->Serial: Communicate data through serial port (Setting preferable

Com Port)

8. Language: Click to select preferable language

9. Information: Click to display program version information.

4.5.3 Communication over Network or serial port

Click to open system parameter -> Write to DVR

The below window will be activated on