Universal Robots E Series

7.Software installation
This section describes how to configure the IMMImodule software. For information on installing the
IMMImodule hardware, see 6.Hardware installationon page12.
7.1. Configuring the IMMI module software
To configure the IMMI module software
1. On PolyScope, in the Header, tap Installation and select Safety.
2. Tap Hardware and unlock the options on the Select available hardware screen.
A password is required to unlock this screen.
3. In the Injection molding machine interface drop-down list, select the desired
recommendation.
4. Tap Apply to restart the system. PolyScope continues to run.
5. Tap Confirm Safety Configuration to complete the IMMI software installation.
Installation Guide 15
e-Series Injection Molding Machine
Interface (IMMI)
7.Software installation
Copyright © 2019–2021 by UniversalRobotsA/S. All rights reserved.