Universal Robots E Series

1.Introduction
1.1. About this document
This guide describes how to install a UniversalRobots Injection Molding Machine Interface (IMMI)
module on a UniversalRobots e-Series control box and how to configure the Injection Molding
Machine Interface (IMMI) software, to interface with an Injection Molding Machine (IMM).
1.2. What's in the box
The box contains the following parts:
•
IMMI module
•
Cables:
•
EUROMAP67 / SPI AN-146
•
Ribbon cable
•
Ground (GND) wire:
•
M6 nut
•
M6 washer
•
Universal Robots EUROMAP67bypassplug
•
This document
1.3. Company Details
UniversalRobotsA/S
Energivej 25, 5260 Odense S, Denmark
+45 89 93 89 89
https://www.universal-robots.com
Installation Guide 1
e-Series Injection Molding Machine
Interface (IMMI)
1.Introduction
Copyright © 2019–2021 by UniversalRobotsA/S. All rights reserved.