Universal Robots E Series Installation Guide

3.3. Requirements
The serial number of the control box must be newer than 2020020161. The hardware revision of the
safety control board electronics is Rev.F2.
NOTICE
Installing an e-Series Injection Molding Machine Interface (IMMI) in a control box
with a serial number lower than 2020020161 can result in damage to equipment or
property.
•
Verify your control box serial number before installing the IMMI module.
•
You can verify your safety control board if necessary.
Control box
The control box serial number is located on the underside of the control box bracket. The following
illustration shows the label and the control box serial number.
e-Series Injection Molding Machine
Interface (IMMI)
8 Installation Guide
3.Product description
Copyright © 2019–2021 by UniversalRobotsA/S. All rights reserved.

Universal Robots E Series Specifications

General

Brand	Universal Robots
Model	E Series
Category	Robotics
Language	English