Universal Robots E Series Installation Guide

12.Copyright and disclaimers
The information contained herein is the property of UniversalRobotsA/S and shall not be
reproduced in whole or in part without prior written approval of UniversalRobotsA/S. The
information herein is subject to change without notice and should not be construed as a
commitment by UniversalRobotsA/S. This document is periodically reviewed and revised.
UniversalRobotsA/S assumes no responsibility for any errors or omissions in this document.
Copyright © 2019–2021 by UniversalRobotsA/S.
The UniversalRobots logo is a registered trademark of UniversalRobotsA/S.
NOTICE
UniversalRobots continues to improve reliability and performance of its products,
and therefore reserves the right to upgrade the product without prior warning.
UniversalRobots takes care that the content of this document is precise and correct,
but takes no responsibility for any errors or missing information.
UniversalRobots disclaims any liability, even if all guidelines in this document are
followed.
NOTICE
The UniversalRobots e-Series Injection Molding Machine Interface (IMMI) has been
developed in accordance with Euromap 67, version 1.11 (May 2015 edition) and SPI
AN146, The Society of the Plastics Industry, publication No. AN146 (March 2006).
UniversalRobots hereby disclaim any and all liability with respect to the IMM and its
signal to the IMMI, including stop signals and its handling of the Universal Robots
stop signals, as Universal Robots has no knowledge whether the IMM is developed
in compliance with the aforementioned industry guidelines.
Installation Guide 29
e-Series Injection Molding Machine
Interface (IMMI)
12.Copyright and disclaimers
Copyright © 2019–2021 by UniversalRobotsA/S. All rights reserved.

Universal Robots E Series Specifications

General

Brand	Universal Robots
Model	E Series
Category	Robotics
Language	English