WARNING
Incorrect connection of the power source or ground wires can result in personnel
injury or equipment damage.
Damage caused by invalid power source connection is not covered by warranty.
Before starting the operation:
•
Ensure the power source wiring is correct.
•
Ensure the grounding is correct.
WARNING
Failure to verify and validate the safeguarding and funtionality of the IMMImodule
can result in death or serious injury.
•
Ensure all risk reduction works as intended and achieves the needed risk
reduction.
WARNING
Failure to perform a risk assessment before installing and operating the
IMMImodule can result in personnel injury or equipment damage.
•
Perform a risk assessment before installing and operating the IMMImodule.
•
Read the UniversalRobotse-Series Robot User Manual and Service Manual.
WARNING
This product includes the UniversalRobotse-Series robot. General safety
considerations that are valid for the UniversalRobotse-Series robot are also valid
for this product.
Failure to use the robot as described in the User Manual can lead to personnel
injury.
•
For more information on safety, refer to the Safety section in the
UniversalRobotse-Series robot UserManual.
2.3. IMMI safety precautions
This section contains safety precautions specific to installing the IMMI.
Installation Guide 3
e-Series Injection Molding Machine
Interface (IMMI)
2.Safety
Copyright © 2019–2021 by UniversalRobotsA/S. All rights reserved.
To Next Page
Need help?
General
