22.1. MODBUS
Description The screenshot below displays the MODBUS client I/O signals as they are set up in
the installation.
Using the drop-down menus at the top of the screen, you can change the displayed
content based on signal type and MODBUS unit if more than one is configured.
Each signal in the lists contains its connections status, value, name, and signal
address.
The output signals can be toggled if the connection status and the choice for I/O tab
control allows it. See 22 I/O Tab on page322
UR10e 324 User Manual
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
