Universal Robots UR10e PolyScope X - Applied Standards

14.Applied Standards
Description This section describes relevant standards applied to the
development and manufacturing of the UR robot, including the
robot arm, Control Box and Teach Pendant .
A standard is not a law, but a document developed by stakeholders
within a given industry. Standards contain requirements and
guidance for a product or product group.
The abbreviations in this manual and their meaning are listed in the
table below:
Abbreviations in this
document
ISO International
Organization for
Standardization
IEC International
Electrotechnical
Commission
EN European Norm
TS Technical
Specification
TR Technical Report
ANSI American National
Standards Institute
RIA Robotic Industries
Association (now
known as “A3”)
CSA Canadian
Standards
Association
Applied
Standards
Maintaining robot compliance with the following standards requires
adhering to the assembly instructions, safety instructions and
guidance in this manual. For the safety of the robot application, the
integrator is required to comply with ISO 10218-2. Unauthorized
modifications invalidate the Declaration of Incorporation (DOI),
certifications and conformity of the robot.
UR robots comply with the relevant requirements in the applied
standards. Applicable test reports and certifications included in this
manual and the standards are listed in the Declaration of
Incorporation.
The standards applicable to this manual are listed in the table
below:
UR10e PolyScope X 104 User Manual
14.Applied Standards
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.