Universal Robots UR10e PolyScope X - Validity and Responsibility; Limitation of Liability

2.1. Validity and Responsibility
Description The information in this manual does not cover designing, installing, integrating and
operating a robot application, nor does it cover all peripheral equipment that can
influence the safety of the robot application. The robot application must be designed
and installed in accordance with the safety requirements set forth in the relevant
standards and regulations of the country where the robot is installed.
The person/s integrating the UR robot are responsible for ensuring that the applicable
regulations in the country concerned are observed and that any risks in the robot
application are adequately reduced. This includes, but is not limited to:
•
Performing a risk assessment for the complete robot system
•
Interfacing other machines and additional safeguarding if required by the risk
assessment
•
Setting the correct safety settings in the software
•
Ensuring safety measures are not modified
•
Validating the robot application is designed, and installed and integrated
•
Specifying instructions for use
•
Marking the robot installation with relevant signs and contact information of the
integrator
•
Retaining all documentation; including the application risk assessment, this
manual and additional relevant documentation.
2.2. Limitation of Liability
Description Any information provided in this manual must not be construed as a warranty, by UR,
that the industrial robot will not cause injury or damage, even if the industrial robot
complies with all safety instructions and information for use.
User Manual 15 UR10e PolyScope X
2.Safety
Copyright © 2009–2024 by UniversalRobotsA/S. All rights reserved.