Upright LX31 Service Manual

Switch Adjustments Section 2 - Service and Repair
Page 2-12 067448-023 LX31/LX41 Electric and Bi-Energy Work Platform | European Specifications
2-6 S
WITCH
A
DJUSTMENTS
P ROXIMITY S WITCH - S ERIAL N UMBER 4022-4274
Figure 2-6:
Proximity Switch, Serial Number 4022-4274
The Proximity Switch is located near the front
right corner of the chassis under the elevating
assembly. Its function is determined by the loca-
tion of the lower elevating assembly tube.
P ROXIMITY S WITCH F UNCTION ,
S
ERIAL N UMBER 4022-4274
The Proximity Switch controls the machine
operation.
Platform Elevated:
• The switch is open.
• The Level Sensor is enabled.
• Power to the High Speed Circuit is cut, preventing the machine from travel faster than 0,8 km/h
(0.5 mph).
Figure 2-7:
Proximity Switch Position
Platform Lowered:
• The switch is closed.
• Power is supplied to the High Speed Circuit,
allowing the machine to travel up to 3,2 km/h
(2.0 mph) when the Platform Controls Drive
Speed Switch is set to HI SPEED.
T EST THE P ROXIMITY S WITCH ,
S ERIAL N UMBER 4022-4274
1. Place the machine on a firm, level surface.
2. Use an inclinometer to ensure that the chas-
sis is level from front to rear and side to side.
3. Deploy the maintenance brace (see “Blocking The Elevating Assembly” on page 2-8).
4. Disconnect the switch leads and connect a multimeter to the switch.
• The switch contacts should be OPEN (no continuity).
• Push the lever down to close the switch contacts. If there is no continuity, the switch is defective.
5. Connect the switch leads, store the maintenance brace and lower the work platform.
6. Elevate the work platform not more than 1 m (3ft.).
7. With the Platform/Chassis switch on CHASSIS, push the Tilt Sensor base to test the alarm circuit.
• If the alarm does not sound, the switch is out of adjustment.
8. Turn the Drive Speed Switch to HI SPEED and attempt to drive the machine.
• If the machine will drive faster than 0,8 km/h (0.5 mph), the switch is out of adjustment.
9. Lower the work platform completely.
1
3
2
4
1. Proximity Switch in OPEN position
2. Proximity Switch in CLOSED position
3. Chassis
4. Inner Elevating Assembly Tube
FRONT

Upright LX31 Specifications

General

Brand	Upright
Model	LX31
Category	Lifting Systems
Language	English