Outrigger Cylinder (Optional) Section 2 - Service and Repair
Page 2-30 067448-023 LX31/LX41 Electric and Bi-Energy Work Platform | European Specifications
2-14 O
UTRIGGER
C
YLINDER
(O
PTIONAL
)
R
EMOVAL
Refer to Figure 2-25.
1. Remove the plug from the top of the outrigger cylinder.
2. Disconnect the wires from the pressure Switch and the ball Switch. Tag them for identification during
reassembly.
3. Unscrew the strain relief and pull the wires out of the top of the cylinder.
4. Remove and cap the hoses. Tag them for identification during reassembly.
5. Remove the four capscrews, nuts, and washers holding the outrigger cylinder to the outrigger support
weldment.
6. Remove the outrigger cylinder.
S
EAL
R
EPLACEMENT
Refer to “Cylinder Repair” in the General Information section, and Figure 2-26.
I
NSTALLATION
1. Install the outrigger cylinder to the outrigger support weldment using the four capscrews, nuts, and
washers; tighten.
2. Install the hoses exactly as disassembled.
3. Thread the wires for the pressure Switch and the ball Switch through the strain relief.
4. Reattach the wires to the Switches exactly as disassembled.
5. Tighten strain relief.
6. Install plug to top of outrigger cylinder.
To Next Page
Loading...
Need help?
General
