9. Thread the Ethernet cable through the PG21 conduit connector and the camera housing
as shown in No. 9, Figure B-7.
10. Rotate the plastic ring to secure the conduit connector to the camera housing. Screw in
the cap as shown in No. 10, Figure B-7.
11. Plug the Ethernet cable to the RJ-45 connector of the camera as shown in No. 11, Figure
B-7. To waterproof the Ethernet cable, see E.Waterproofing the Cable.
12. Screw the wall box mount to the camera housing as shown in No. 12, Figure B-7.
Figure B-7
13. Mount the bottom ring.
Figure B-8
To Next Page
Loading...